Most water heaters still in use today are either electric resistance (ER) or gas. ER water heaters use electricity to directly heat water. In both cases, water comes out of the ground, aquifer, reservoir, or other municipal water source you have, and is then heated from whatever temperature that is to 120°F or whatever you have your water heater set at. This is just plain silly and very, very inefficient.
Traditional water heaters operate by constantly heating the stored water to keep at the temperature set on the thermostat. These heaters usually have a tank with a capacity of 35 to 50 gallons. This is enough water to supply multiple water fixtures at the same time. … These gases rise heating the water tank.
A traditional water type tank should last you 8 -12 years here are 7 tell tale signs that your hot water heater may not be working well
- You don’t have enough hot water. …
- You have varying water temperature issues. …
- You have a leaking water heater. …
- You notice reduced water flow. …
- You’re hearing some concerning sounds. …
- You have smelly or discoloured water. …
- Your water heater is on the older end of the spectrum.
Most homeowners should flush their water heaters every six months or so, but if you have extremely hard water, you may want to do it more often. Flushing your hot water heater could be necessary as often as every few months depending on the mineral content of your local water supply.
Leave a Reply